Step
A: This is the way you receive your Water Softener
from “On The Go™”. It has the female
adaptor on the inlet side that you can connect your incoming
water hose to and a male hose adaptor on the outlet side
that you can connect your outgoing water hose or flow
meter.
Step B: Connect hose to water supply
and to softener inlet side.
Step C: Flush system of softener by running
water through the unit for five to ten minutes. Note:
The softener does not require salt or regeneration when
received. Unit contains Cation Exchange Resin which is
light amber to black spherical beads-DO NOT REMOVE.
Step D: Next, thread on flow meter to
outlet. The minimum specification flow rate is 2 gallons/min
and is required for the unit to meter water flow.
Step E: Connect white drinking water
hose to the male hose adaptor on the outlet side or flow
meter if used and to RV water supply inlet connection.
Step F: Set dial on flow meter to your
selected set point between 300 to 700 gallons [This setting
will vary based upon hardness of water source]. See insert
“Options For Portable Water Softener Hookup”
for detailed instructions.
Dealers! Did you know you can now enter
your purchase orders through your own password protected area on this
site? Stop the Faxing! It's easy! Contact Bruce@PortableWaterSoftener.com
• Press:
Portable Water Deionizer Provides Hundreds of Gallons of Pure Water for
Spot Free Rinsing- Promotion at NASCAR 400 Race. Click Here to Read More
Step C: Flush system of softener by running
water through the unit for five to ten minutes. Note:
The softener does not require salt or regeneration when
received. Unit contains Cation Exchange Resin which is
light amber to black spherical beads-DO NOT REMOVE.
