Step 1: Install….twist the test
light into the gray light body. Make sure o-ring is seated
to prevent leaks. Flat side of the light assembly must
run in the direction with the water flow.
Step 2: Install the test light assembly
to the outlet side of the ON THE GO™ Portable Water
Deionizer (DI) tank. Plug the test light into a standard
110V outlet. (The light will remain on as long as DI water
is being produced. Once light goes out, the resin needs
to be replaced.)
Step 3: Connect a hose to the outlet
side of the test light assembly. (Use the quick connects
provided for easy assembly and disassembly. See Optional
Connector Hook-up Addendum For Detailed Instructions).
Step 4: WARNING: Connect water supply
hose to the DI tank inlet side. (DO
NOT HOOK-UP TO OUTLET SIDE, UNIT DAMAGE WILL OCCUR)
Step 5: Turn on the water supply and
you are ready to go with a spot-free, DI water rinsing.
Step 6: When the test light goes out,
the Portable Water DI tank must be regenerated. You can
return unit to ON THE GO™ for resin replacement.
Or, you can simply empty the resin from the tank, rinse
it out and then replace the resin with new resin purchased
from ON THE GO™. You can also find a certified regeneration
professional in the Yellow Pages under “Water Treatment.”
Dealers! Did you know you can now enter
your purchase orders through your own password protected area on this
site? Stop the Faxing! It's easy! Contact Bruce@PortableWaterSoftener.com
• Press:
Portable Water Deionizer Provides Hundreds of Gallons of Pure Water for
Spot Free Rinsing- Promotion at NASCAR 400 Race. Click Here to Read More
Step 2: Install the test light assembly
to the outlet side of the ON THE GO™ Portable Water
Deionizer (DI) tank. Plug the test light into a standard
110V outlet. (The light will remain on as long as DI water
is being produced. Once light goes out, the resin needs
to be replaced.)
